American Dynamics intellex dvms インストール手順
8200-0743-01 B0
1
Intellex Software Version
4.0 to 4.1 Upgrade
This bulletin describes the CD upgrade for Intellex 4.0 to 4.1 Intellex version software. You must
have Windows XP SP2 installed in order to perform this upgrade.
have Windows XP SP2 installed in order to perform this upgrade.
Intellex IP and Ultra now support a monitor resolution of 1024 x 768 only. Any users who wish to
upgrade to v4.1 or purchase a new system must ensure that their monitor supports a 1024 x 768
resolution display. Intellex DVMS and LT can still operate on an 800 x 600 resolution monitor.
upgrade to v4.1 or purchase a new system must ensure that their monitor supports a 1024 x 768
resolution display. Intellex DVMS and LT can still operate on an 800 x 600 resolution monitor.
Note
Qualified personnel performing this upgrade should have Intellex certification.
Instructions
1 Insert the software upgrade CD-ROM into the CD drive of the Intellex unit. For DVMS insert
CD-ROM 1 and for Ultra insert CD-ROM 2.
2 Exit Intellex.
3 Navigate to your CD drive and double-click on Setup.exe. Follow the prompts to install the
Intellex upgrade.
Note
The unit may reboot several times and appear to be starting the upgrade again. This is normal.
Depending on your computer speed, the reboot process may take up to 15 minutes.
Depending on your computer speed, the reboot process may take up to 15 minutes.
4 At the end of the installation, the Intellex will automatically turn itself off.
5 Turn on the Intellex and check that the installation was successful by clicking Utility > About
Intellex. Software version 4.1 should appear.