Open House h480-2 プリント

ページ / 2
H480-2 INSTALLATION INSTRUCTIONS
®
PRINTER’S INSTRUCTIONS:
INSTR,INSTL,H480-2 - LINEAR P/N: 224104 X2 - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 8.500" X 11.000" - SCALE: 1-1 - SIDE 1 OF 2
ABOUT THE H480-2 MOUNTING CLAMP DESIGN
The H480-2 speaker features rigid, heavy-duty 
mounting clamps that ensure a quick, secure, 
vibration-free installation in walls from 1/2” to 1-1/2” in 
thickness.
The H480-2 model has four mounting clamps.
DAMPING THE WALL CAVITY
Damping the wall/ceiling cavity behind the speakers 
by loosely filling it with fire-rated fiberglass insulation 
can enhance the performance of your speakers and 
reduce unwanted transmission of sound into adjacent 
rooms.
PAINTING THE SPEAKERS
All speakers can be finished to match any room décor. 
Their white, textured frames and no-rust aluminum 
grilles readily accept most water-based interior latex 
and spray enamels.
We recommend the grille and frame be painted 
separately. To aid in frame painting, we’ve included a 
plastic paint shield that will protect the speaker baffle.
Painting Tips:
1. If not using spray paint, we recommend that the 
paint be thinned to prevent clogging the speaker 
grille perforations.
2. When painting, several light coats will yield the 
best results.
As the installation of flush-mount speakers requires 
cutting into walls where high-voltage wiring, pipes 
and duct work may be present, installation should be 
performed by experienced and trained professionals 
only.
NOTES:
• 
Check for Obstructions––Before cutting holes 
in any existing wall or ceiling surface, the cavity 
behind each speaker’s installation location MUST 
be probed for obstructions. Make sure to probe 
both speaker locations in the room to ensure that 
symmetrical placement is feasible.
• 
New Construction Installation—In new 
construction installations, the H481-6 mounting 
brackets can be used to mount the H480-2 
speakers. The H481-6 brackets can be 
mounted before the drywall is installed. Visit 
the openhousesystem.com web site for further 
information.
•  Always maintain proper polarity when wiring 
speakers. Failure to do so will result in poor stereo 
imaging and a decrease in base response.
CUTTING SPEAKER OPENINGS IN FINISHED WALLS
1. Use a stud finder to locate the studs around the 
intended speaker placement. 
NOTE: A stud-
finding device MAY NOT detect pipes, wiring, or 
other obstructions located behind the drywall.
2. Use the inside portion of the speaker cutout 
template to confirm the speaker placements.
3. Remove templates and drill or carefully poke a 
pilot hole in both locations. A bent piece of wire 
or a coat hanger may be used to probe the stud bay 
for obstructions. If you experience resistance of 
any kind––STOP! If any obstructions are detected, 
patch the pilot holes and try again in another 
location.
4.  Once you have determined the cavity is free from 
obstructions, re-position the cutout template and 
use a pencil to lightly trace the perimeter of the 
tem-plate.
5.  Use a keyhole saw, drywall router, or razor knife to 
cut the openings.
IN-CEILING SPEAKER INSTALLATION:
Complete Assemblies  
(with or without New  
Construction Brackets)
1. Remove speaker grille
2. Locate the speaker wire and pull through the 
ceiling opening.
IMPORTANT NOTE: The slim design 
of the H480-2 speaker frame flanges 
require that careful attention be paid 
to not oversize the cut-out hole.