Panasonic AG-HVX200 ユーザーガイド

PAGE/

AUDIO MON/VAR

If you are monitoring the sound through 
headphones while shooting, you can adjust the 
volume with the PAGE/AUDIO MON/VAR button.
•  To adjust the recording level (Page 53)

If you have connected equipment to the 1394 
terminal (pages 77 and 78), you can make 
automatic backup recordings of whatever you are 
shooting.
•  In the setup menus, OTHER FUNCTIONS 

screen, 1394 CONTROL and 1394 CMD SEL, 
select how to control the equipment you have 
connected. (Page 114)

•  Select the settings below for the following items 

on the DISPLAY SETUP screen (page 112) for 
backup recording when using a tape.

  •  OFF for VIDEO OUT OSD
  •  OFF for DATE/TIME

Note the following when backup recording.
•  When performing backup recording while a tape 

is used:

 •  

If either of the following settings have been 
selected, 

output at all times except when the unit is in 
the recording mode.

  -  

When ON has been set for the VIDEO OUT 
OSD option on the DISPLAY SETUP screen 
(page 112)

  -  

When a setting other than OFF has been 
selected for the DATE/TIME option on the 
DISPLAY SETUP screen (page 112)

 •  

Bear in mind that the OSD may be recorded 
inadvertently if backup recording is performed 
when a setting other than OFF is selected for 
the 1394 CONTROL option (page 114) on the 
OTHER FUNCTIONS screen.

 •  

If the DATE/TIME button on the remote control 
is pressed, 

to the 1394 output regardless of whether 
recording is underway or the recording 
standby status is established.

•  Menu settings are retained even if you turn the 

power off. So if you use the camera-recorder with 
the settings for backup recording still in effect, 
images on media in any unit that connected may 
be overwritten. After backup recording, check 
the menu item settings before you operate the 
camera-recorder.

•  If you use another AG-HVX200 as the external 

unit for backup recording, select “OFF” for 1394 
CONTROL on the external unit and set it to MCR/
VCR mode.

•  Backup recording may not work properly if you 

connect two or more external units.

•  Use a DV (IEEE1394) cable of 4.5 m or less for 

connection.

•  Set the external unit up to receive 1394 signals 

before backup recording.

•  You can have a media in the external unit start 

recording automatically when the media in this 
unit is almost finished. Set 1394 CONTROL 
(page 114) to “CHAIN”.

•  Note that images are recorded even when you 

perform a rec check if a P2 card is being used: 
When a tape is used, no images are output 
during rec check.

•  You cannot perform backup recording when the 

unit is set up for native recording.

•  Backup recording does not work in three of 

the special recording modes of the P2 card: 
Interval recording, One-shot recording and Loop 
recording. (Pages 47 and 48)

•  Backup recording does not work during direct 

shooting (page 66) in MCR mode.