Sony CDX-F5500 仕様ガイド
2004 SONY MOBILE
PRODUCT GUIDE
CDX-F5500
FM/AM Compact Disc Player
Audio Power Specifications
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
23.2 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 5%
total harmonic distortion
Note
This unit cannot be connected to a digital preamplifier or an equalizer
which is Sony BUS system compatible.
Design and Specifications subject to change without notice.
CD Player Section
Signal-to-noise ratio
120 dB
Frequency Response
10 - 20,000 Hz
Stereo Separation
85 dB
Total Harmonic Distortion
0.01%
Tuner Section
FM
AM
Tuning Range
87.5 - 107.9 MHz
Tuning Range
530 - 1,710 kHz
Antenna Terminal
External antenna connector
Antenna Terminal
External antenna connector
Intermediate Frequency
10.7 MHz/450 kHz
Intermediate Frequency
10.7 MHz/450 kHz
Usable sensitivity
9 dBf
Sensitivity
30 µV
Selectivity
75 dB at 400 kHz
Signal-tp-noise ratio
67 dB (stereo), 69 dB (mono)
Harmonic distortion at 1 kHz
0.5% (stereo), 0.3% (mono)
Separation
35 dB at 1 kHz
Frequency response
30 - 15,000 Hz
Outputs
Speaker outputs (sure seal connectors)
Speaker impedance
4 - 8 ohms
Maximum power output
52 W x 4 (at 4 ohms)
Power Amplifier Section
General
• MP3 Playback
• Station Memo
• Front preamp output
• Rear/Sub selectable preout
w/LPF
• CD/MD changer control, CD Text
• Flip-down detachable faceplate
• DSO, EQ3
• 52W x 4 high power
• Drive-S
• 8fs, 1-bit D/A converter
• 45 degree install
• CD-R/RW playback
• SSIR-EXA tuner
• 18FM + 12AM memory presets
• Blue 13-segment LED display
• Red key illumination
• Supplied wireless card remote
(RM-X115)
• Optional wired rotary remote
(RM-X4S)
Preamp Output Level
2 Volts
Preamp Impedance
220 ohms
Outputs
Audio outputs (front, rear/sub selectable)
Power antenna relay control terminal
Power amplifier control terminal
Inputs
Telephone ATT control terminal
BUS control input terminal
BUS audio input terminal
Remote controller input terminal
Antenna input terminal
Tone controls
Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1kHz (XPLOD)
High: ±10 dB at 10kHz (XPLOD)
Power requirements
12 V DC car battery (negative ground)
Dimensions
Approx. 178 x 50 x 177 mm
(7 1/16 x 2 x 7 in.) (w/h/d)
Mounting dimensions
Approx. 182 x 53 x 161 mm
(7 1/4 x 2 1/8 x 6 3/8 in.) (w/h/d)
Mass
Approx. 1.2 kg (2 lb. 10 oz.)
Supplied accessories
Card remote commander (RM-X115)
Parts for installation and connections
Front panel cover (1)
Optional accessories
Rotary remote commander (RM-X4S)
Plug shown with wires facing viewer
Pin Number
Wire Color
Description
1
White
Left front +
2
Green
Left rear +
3
Purple
Right rear +
4
Gray
Right front +
5
Blue/white
AMP Remote
6
Blue
ANT Remote
7
Red
Accessory
8
Black
Ground
9
White/black
Left front -
10
Green/black
Left rear -
11
Purple/black
Right rear -
12
Bray/black
Right front -
13
Sky blue
ATT
14
15
Orange/white
Illumination
16
Yellow
Battery
Harness Plug Configuration
1
2
3
4
5
6
7
8
9 10 11 12 13 14 15 16