3com 8807 参照ガイド
1080
C
HAPTER
66: NQA C
ONFIGURATION
C
OMMANDS
■
When probing, the system sends one packet every time. While the test process
is not always so.
is not always so.
■
One test may include many probes. The test succeeds as long as there is one
successful probe.
successful probe.
■
The current "probe failure times" will be reset to zero after a test is finished,
that is, the "times" is only valid for a single test and can not cross two tests for
constant statistics. If the probe succeeds, this statistic value is reset to zero too.
that is, the "times" is only valid for a single test and can not cross two tests for
constant statistics. If the probe succeeds, this statistic value is reset to zero too.
Related command: test-failtimes.
Example
# Set that the system sends Trap information after 3 times constant probe failures
in an NQA test.
in an NQA test.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] nqa-agent enable
[SW8800] nqa administrator icmp
[3Com-administrator-icmp] probe-failtimes 3
sendpacket passroute
Syntax
sendpacket passroute
undo sendpacket passroute
View
NQA test group view
Parameter
None
Description
Use the sendpacket passroute command to assume the connection mode
between the destination address and the equipment which enables the test as
direct connection mode. So called direct connection mode is that the connection
between the destination address and the equipment enabling the test is not
through the Layer 3 data exchange equipment.
between the destination address and the equipment which enables the test as
direct connection mode. So called direct connection mode is that the connection
between the destination address and the equipment enabling the test is not
through the Layer 3 data exchange equipment.
Use the undo sendpacket passroute command to cancel this assumption.
By default, no such assumption
n
■
If you assume the connection mode to the destination address as direct
connection mode, actually it equals to set the TTL to 1.
connection mode, actually it equals to set the TTL to 1.
■
If you assume the connection mode as direct mode, but set the TTL value at the
same time, then the TTL value does not take effect. This value takes effect
when you cancel the configuration on the connection mode.
same time, then the TTL value does not take effect. This value takes effect
when you cancel the configuration on the connection mode.