3com 8807 参照ガイド
132
C
HAPTER
10: E
THERNET
P
ORT
C
ONFIGURATION
C
OMMANDS
Example
# Display the inbound statistics on the GigabitEthernet ports.
<SW8800> display counters inbound interface GigabitEthernet
Interface Total(pkts) BroadCast(pkts) MultiCast(pkts) Err(pkts)
GE3/2/1 12,345,678,912,345 OverFlow 12,345,678,912,345 1,234,567
GE3/2/2 0 0 0 0
GE3/2/3 0 0 0 0
GE3/2/4 0 0 0 0
OverFlow :more than 14 decimal digits(7 digits for column "Err").
:not supported.
n
Statistic values are comma-separated decimal numbers. For the Total, BroadCast
and MultiCast items, decimal numbers of 14 digits can be displayed at most, and
those of more than 14 digits are indicated with "OverFlow"; for the Err item,
decimal numbers of 7 digits can be displayed at most, and those of more than 7
digits are indicated with "OverFlow".
and MultiCast items, decimal numbers of 14 digits can be displayed at most, and
those of more than 14 digits are indicated with "OverFlow"; for the Err item,
decimal numbers of 7 digits can be displayed at most, and those of more than 7
digits are indicated with "OverFlow".
display interface
Syntax
display interface [ interface-type | interface-type interface-number [ packets] ]
View
Any view
Parameter
interface-type: Specifies the port type.
interface-number: Specifies the port number.
For parameter description, refer to the interface command.
Description
Use the display interface command to view the configuration information on the
port.
port.
If the port type and number are not specified when displaying the port
information, the information of all the ports will be displayed. If only the port type
is specified, all the information of the ports of this type will be displayed. If both
port type and port number are specified, the information of the designated port
will be displayed.
information, the information of all the ports will be displayed. If only the port type
is specified, all the information of the ports of this type will be displayed. If both
port type and port number are specified, the information of the designated port
will be displayed.
Example
# Display configuration information of Ethernet2/1/1.
<SW8800> display interface ethernet2/1/1
Ethernet2/1/1 current state : UP
IP Sending Frames’ Format is PKTFMT_ETHNT_2, Hardware address is
00e0-fc00-85ff
The Maximum Transmit Unit is 1500
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
100Mbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 1552
Broadcast MAX-ratio: 100%