3com 8807 参照ガイド
66
NQA C
ONFIGURATION
C
OMMANDS
NQA Configuration
Commands
Commands
This section describes the Network Quality Assurance(NQA) commands.
count
Syntax
count times
undo count
View
NQA test group view
Parameter
times: Number of probe packets to send.
Description
Use the count command to configure the number of probe packets to send.
Use the undo count command to restore the number of probe packets to send to
the default value.
the default value.
By default, one probe packet is sent.
n
If you specify a value bigger than 1 for the times argument, the system operates in
either of the following two ways after sending the first probe packet.
either of the following two ways after sending the first probe packet.
■
If the system receives a response packet, it sends a second probe packet.
■
If the system does not receive a response packet, it sends a second probe
packet after test operation timeout.
packet after test operation timeout.
This process goes on until the last probe packet is sent
Example
# Set the number of probe packets to send to 5.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] nqa administrator icmp
[3Com-administrator-icmp] count 5
datafill
Syntax
datafill text
undo datafill