3com 8807 ユーザーガイド
34
C
HAPTER
3: L
OGGING
IN
TO
S
WITCH
Figure 3 Configure the port for connection
Figure 4 Set communication parameters
Step 3: The switch is powered on. Display self-test information of the switch and
prompt you to press Enter to show the command line prompt such as <SW8800>.
prompt you to press Enter to show the command line prompt such as <SW8800>.
Step 4: Input a command to configure the switch or view the operation state.
Input a "?" for help. For details of specific commands, refer to the following
chapters.
Input a "?" for help. For details of specific commands, refer to the following
chapters.
Setting up
Configuration
Environment through
Telnet
Configuration
Environment through
Telnet
Connecting a PC to the
Switch through Telnet
After you have correctly configured IP address of a VLAN interface for a switch via
Console port (using ip address command in VLAN interface view), and added the
port (that connects to a terminal) to this VLAN (using port command in VLAN
view), you can telnet this switch and configure it.
Console port (using ip address command in VLAN interface view), and added the
port (that connects to a terminal) to this VLAN (using port command in VLAN
view), you can telnet this switch and configure it.