3com 8807 ユーザーガイド
270
C
HAPTER
27: P
ORTAL
C
ONFIGURATION
Basic Portal
Configuration
Configuration
Configuration
Prerequisites
■
A valid IP address has been configured for this portal-enabled VLAN interface.
■
802.1x is not enabled on the switch.
■
The Portal server has been installed and configured. Refer to CAMS Portal
Service Components User’s Guide for details about installation and
configuration.
Service Components User’s Guide for details about installation and
configuration.
n
■
Refer to the "Network Protocol" section in 3Com Switch 8800 Family Series
Routing Switches-Operation Manual for DHCP configuration.
Routing Switches-Operation Manual for DHCP configuration.
■
Refer to Chapter 2 AAA&RADIUS Protocol Configuration for AAA&RADIUS
configuration.
configuration.
Basic Portal
Configuration Procedure
The following table describes the basic Portal configuration procedure.
Table 244 Basic Portal configuration procedure
Operation
Command
Description
Enter system view
system-view
-
Configure the Portal server
portal server server-name {
ip ip-address | key key-string |
port port | url url-string } *
ip ip-address | key key-string |
port port | url url-string } *
Required
No Portal server is configured
by default. When a Portal
server is configured, the
key-string is 3Com, the port is
50100 and the url-string is the
string format of ip-address by
default.
by default. When a Portal
server is configured, the
key-string is 3Com, the port is
50100 and the url-string is the
string format of ip-address by
default.
Configure the running
method of Portal
method of Portal
portal method { direct |
layer3 | redhcp }
layer3 | redhcp }
Optional
The direct authentication
method is adopted in Portal
authentication by default.
method is adopted in Portal
authentication by default.
Configure the authentication
network segment
network segment
portal auth-network
network-address net-mask
vlan vlan-id
network-address net-mask
vlan vlan-id
This command must be
configured if the Layer 3
authentication method is
adopted in Portal
authentication. This
procedure is omitted in other
methods.
configured if the Layer 3
authentication method is
adopted in Portal
authentication. This
procedure is omitted in other
methods.
Configure the interval of
handshakes with user PCs and
the maximum retry times
handshakes with user PCs and
the maximum retry times
portal arp-handshake {
interval interval | retry-times
retry-times }*
interval interval | retry-times
retry-times }*
Optional
This task is effective only for
the Direct authentication
method and the ReDHCP
authentication method. By
default, the interval of ARP
handshakes is 60 seconds,
and the maximum retry times
is five times.
the Direct authentication
method and the ReDHCP
authentication method. By
default, the interval of ARP
handshakes is 60 seconds,
and the maximum retry times
is five times.
Enter VLAN interface view
interface vlan-interface
vlan-id
vlan-id
The following displayed
information in VLAN interface
view is corresponding to the
input vlan-id
information in VLAN interface
view is corresponding to the
input vlan-id