3com S7906E インストール手順
1-4
NQA Test Operation
An NQA test operation is as follows:
1) The NQA client constructs packets with the specified type, and sends them to the peer device;
2) Upon receiving the packet, the peer device replies with a response with a timestamp.
3) The NQA client computes the packet loss rate and RTT based on whether it has received the
response and the timestamp in the response.
NQA Configuration Task List
For TCP, UDP jitter, UDP echo or voice tests, you need to configure the NQA server on the peer device.
Follow the step below to enable the NQA server:
Task
Remarks
Required for TCP, UDP echo, UDP jitter and
voice tests
voice tests
To perform an NQA test successfully, make the following configurations on the NQA client:
1) Enable the NQA client;
2) Create a test group and configure test parameters according to the test type. The test parameters
may vary with test types;
3) Start the NQA test;
After the test, you can view test results using the display or debug commands.
Complete these tasks to configure NQA client:
Task
Remarks
Required
Required
Required
Use any of the approaches
Optional
Optional
Optional
Optional