3com S7906E インストール手順

 

1-20 

As shown in 

, the number of PCs on the enterprise network is outgrowing the number of ports 

available on the access switches. To accommodate to business growth, the number of ports at the 

access layer must be increased while the present investments of the customer are protected. In 

addition, the ease of management and maintenance must be ensured.  

Figure 1-8 Network diagram for IRF (using BFD MAD detection) 

XGE1/3/0/25
(IRF-port1/2)

XGE2/3/0/25
(IRF-port2/1)

GE1/3/0/1

GE2/3/0/1

Device A

Device B

Note: The solid orange line represents the IRF link; the solid magenta line represents 

link used for LACP MAD detection; the solid black lines represent Ethernet links.

IP network

 

 

z 

To increase the number of access ports, additional devices are needed. In this example, Device B 

is added. 

z 

To address the requirements for high availability, ease of management and maintenance, use IRF2 

technology to create an IRF with Device A and Device B at the access layer. 

z 

To offset the risk of IRF splits, configure MAD to detect multi-active IRF collisions.  In this example, 

BFD MAD is adopted because the downlinks of devices are PCs instead of aggregated networking. 

1)  Device A and Device B are not connected. Power them on and configure them separately. 

# Configure Device A. 

<Sysname> system-view 

[Sysname] chassis convert mode irf 

This command will convert the device to IRF mode and the device will reboot. Are you sure? 

[Y/N]: y 

The device reboots automatically to switch its operating mode. After logging in to the device again, 

create IRF-port1/2 of the device, bind it to the physical IRF port Ten-GigabitEthernet 1/3/0/25, and then 

save the configurations. 

<Sysname> system-view