3com S7906E インストール手順
1-28
Configure a proper LSP retransmission interval to avoid unnecessary retransmissions.
Specifying LSP lengths
IS-IS messages cannot be fragmented at the IP layer because they are directly encapsulated in frames.
Therefore, IS-IS routers in an area need to send LSPs smaller than the smallest interface MTU in this
area.
If the IS-IS routers have different interface MTUs, it is recommended to configure the maximum size of
generated LSP packets to be smaller than the smallest interface MTU in this area. Otherwise, the
routers have to dynamically adjust the LSP packet size to fit the smallest interface MTU, which takes
time and affects other services.
Follow these steps to specify LSP lengths:
To do…
Use the command…
Remarks
Enter system view
system-view
––
Enter IS-IS view
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
vpn-instance-name ]
––
Specify the maximum length of
generated Level-1 LSPs or
Level-2 LSPs
generated Level-1 LSPs or
Level-2 LSPs
lsp-length originate size [ level-1 |
level-2 ]
level-2 ]
1497 bytes by default
Specify the maximum length of
received LSPs
received LSPs
lsp-length receive size
1497 bytes by default
Enabling LSP flash flooding
Since changed LSPs may trigger SPF recalculation, you can enable LSP flash flooding to advertise the
changed LSPs before the router recalculates routes. Doing so can speed up network convergence.
Follow these steps to enable LSP flash flooding:
To do…
Use the command…
Remarks
Enter system view
system-view
––
Enter IS-IS view
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
vpn-instance-name ]
––
Enable LSP flash
flooding
flooding
flash-flood [ flood-count flooding-count |
max-timer-interval flooding-interval | [ level-1 |
level-2 ] ] *
max-timer-interval flooding-interval | [ level-1 |
level-2 ] ] *
Required
Not enabled by
default
default
Enabling LSP fragment extension
Follow these steps to enable LSP fragment extension:
To do…
Use the command…
Remarks
Enter system view
system-view
––