3com S7906E インストール手順

1-9

When configuring a multicast static route, you cannot specify an RPF neighbor by providing the type

and number (interface-type interface-number) of the interface connecting the RPF neighbor if the

interface type of the RPF neighbor is Ethernet, Layer 3 aggregate, Loopback, RPR, or VLAN-interface;

instead, you can specify such an RPF neighbor only by its address (rpf-nbr-address).

Configuring a Multicast Routing Policy

You can configure the router to determine the RPF route based on the longest match principle. For

details about RPF route selection, refer to

By configuring per-source or per-source-and-group load splitting, you can optimize the traffic delivery

when multiple data flows are handled.

Configuring a multicast routing policy in the public instance

Follow these steps to configure a multicast routing policy in the public instance:

To do...

Use the command...

Remarks

Enter system view

system-view

—

Configure the device to select
the RPF route based on the
longest match

multicast longest-match

Required

The route with the highest
priority is selected as the RPF
route by default

Configure multicast load
splitting

multicast load-splitting
{ source | source-group }

Optional

Disabled by default

Configuring a multicast routing policy in a VPN instance

Follow these steps to configure a multicast routing policy in a VPN instance: