3com S7906E 参照ガイド
1-48
By default, no static RP is configured.
Note that:
z
IPv6 PIM-SM or IPv6 PIM-DM cannot be enabled on an interface that serves as a static RP.
z
When the IPv6 ACL rule applied on a static RP changes, a new RP must be elected for all IPv6
multicast groups.
z
You can configure multiple static RPs by carrying out this command repeatedly. However, if you
carry out this command multiple times and specify the same static RP address or reference the
same IPv6 ACL rule, the last configuration will override the previous one. If multiple static RPs have
been configured for the same IPv6 multicast group, the one with the highest IPv6 address will be
chosen to serve the group.
z
You can configure up to 50 static RPs on the same device.
Related commands: display pim ipv6 rp-info.
Examples
# Configure the interface with an IPv6 address of 2001::2 as a static RP.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] static-rp 2001::2
timer hello (IPv6 PIM view)
Syntax
timer hello interval
undo timer hello
View
IPv6 PIM view
Default Level
2: System level
Parameters
interval: Hello interval in seconds, with an effective range of 1 to 2,147,483,647.
Description
Use the timer hello command to configure the hello interval globally.
Use the undo timer hello command to restore the system default.
By default, hello messages are sent at the interval of 30 seconds.
Related commands: pim ipv6 timer hello.
Examples
# Set the global hello interval to 40 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] timer hello 40