3com S7906E 参照ガイド
1-9
Field
Description
Active Status
RRPP ring activation status: Yes indicates active and No indicates inactive
The current ring is active only when the RRPP protocol and the RRPP ring
are enabled simultaneously. Through this field, you can get to know the
enable status of the RRPP protocol.
are enabled simultaneously. Through this field, you can get to know the
enable status of the RRPP protocol.
Primary Port
The primary port field means the node mode is master node or transit node.
“-“ appears when the port is not configured on the ring or the board to which
the port belongs does not start.
“-“ appears when the port is not configured on the ring or the board to which
the port belongs does not start.
Secondary Port
The secondary port field means the node mode is master node or transit
node. - appears when the port is not configured on the ring or the board to
which the port belongs does not start.
node. - appears when the port is not configured on the ring or the board to
which the port belongs does not start.
Common Port
The common port field means the node mode is edge node or assistant
edge node. “-“ appears when the port is not configured on the ring or the
board to which the port belongs does not start.
edge node. “-“ appears when the port is not configured on the ring or the
board to which the port belongs does not start.
Edge Port
The edge port field means the node mode is edge node or assistant edge
node. “-“ appears when the port is not configured on the ring or the board to
which the port belongs does not start.
node. “-“ appears when the port is not configured on the ring or the board to
which the port belongs does not start.
Port status
Port status includes down, up and blocked; “-“ appears in one of the
following cases:
following cases:
z
the ring is inactive
z
the port is not configured on the ring
z
the board to which the port belongs does not start
domain ring
Syntax
domain domain-id ring ring-id-list
undo domain domain-id [ ring ring-id-list ]
View
Ring group view
Default Level
2: System level
Parameters
domain-id: RRPP domain ID, in the range of 1 to 8.
ring-id-list: RRPP subring ID list expressed in the format of ring-id-list={ ring-id [ to ring-id ] }&<1-10>,
where the ring-id argument is an RRPP subring ID in the range of 1 to 64 and &<1-10> indicates that
you can input up to ten RRPP ring ID ranges.
Description
Use the domain ring command to configure subrings for a ring group.
Use the undo domain ring command to remove the specified subring(s) from a ring group. If no
subring ID list is specified, all subrings in the ring group are removed in the specified domain.
Note that: