3com S7906E 参照ガイド
1-1
1
Tunneling Configuration Commands
The tunnel interface number is in the A/B/C format, where A, B, and C represent the slot number of a
card, the slot number of a sub-card, and the tunnel interface number, respectively. The value ranges of
A and B vary with devices, and that of C is from 0 to 1023.
Tunnel Configuration Commands
destination
Syntax
destination ip-address
undo destination
View
Tunnel interface view
Default Level
2: System level
Parameters
ip-address: Tunnel destination IPv4 address.
Description
Use the command destination to specify the destination address for the tunnel interface.
Use the undo destination command to remove the configured tunnel destination address.
By default, no tunnel destination address is configured.
Note that:
z
The tunnel destination address is the address of the peer interface receiving packets and should be
configured as the source address of the peer tunnel interface.
z
Two or more tunnel interfaces using the same encapsulation protocol must have different source
and destination addresses.
Related commands: interface tunnel, source.