Xerox 550 ユーザーガイド

■

Check the CopyStation’s front panel for error messages.  Refer to 
the table “CopyStation status and error messages” later in this 
chapter for explanations and possible solutions.

■

To test the CopyStation’s basic functionality, raise the document 
cover, switch the CopyStation’s power off, then switch it on again.  
Looking under the CopyStation’s glass copying area, you should 
see the copier mechanism’s light turn on, the copier mechanism 
should move slightly, and then the light should turn off.

■

The CopyStation’s copier mechanism should be at the end of the 
glass furthest from the front panel.  If it seems stuck in the middle 
of the glass copying area, check the SCSI ID switch on the 
CopyStation’s rear panel — it may be set to 9 (the setting used for 
shipment, which parks the copier mechanism in a safe position).  
If the switch is set to 9, follow the directions in Chapter 2, “Setting 
Up,” to set the switch to a valid SCSI ID.

■

Test the full-length movement of the copier mechanism:

Switch power to the CopyStation off.

Note the CopyStation’s rear panel SCSI ID switch setting.

Change the ID to 8, then perform the power-up test again.

The copier mechanism should travel the full length of the glass 
and return.

If any of these tests or remedies fail, call the Tektronix Customer Support 
Hotline at 1-800-835-6100 in the United States and Canada, or call your 
nearest Tektronix dealer for further assistance.