Xerox 7750 クイック設定ガイド

These procedures eliminate cabling, communication, and connection problems associated with 
network connected printers. The steps are divided into two groups:

■

Novell NetWare Hardware Step-by-Step

■

Novell NetWare Software Step-by-Step

Novell NetWare Software Step-by-Step assumes that you are connected to a Novell 
NetWare network with a Windows OS installed on the client workstation. When both of 
these procedures are completed, print a test page from your software application. If the test 
page prints, no further system troubleshooting is necessary. 

Note the LED activity on the printer. The green link LED is ON whenever it is connected to an 
active network. The amber traffic LED is flickering when data is being received. 

Verify the following:

■

The cable connections: Use a new cable or connectors if possible

■

Which port your printer is attached to. Connect a functioning network device to your 
printer to test the port.

Print the “Configuration Page” from your printer. For information about printing 
Configuration pages, go to 

Reference/Features/Front Panel

.

Review the Connectivity Settings and verify these items:

■

NetWare is enabled

■

Frame Type matches the frame type of the desired file server

To determine your NetWare IPX frame type, type config at the Novell console screen. 
On large networks, using multiple IPX frame types, it is critical that the frame type be 
set correctly.

■

PDL is set to your desired PDL (PostScript or PCL) or to Auto

■

Primary Server (for NetWare 3.x only) is set to the name of the server which serves 
the print queue you have assigned to the Phaser printer

■

NDS Tree (for NetWare 4.x NDS and later) is set for the correct NDS tree name

■

NDS Context (for NetWare 4.x NDS and later) is set for the correct NDS Context

■

Print Server (PServer) Name is set for the name selected for the Phaser printer to act 
as a print server

■

Novell Mode is correctly set

If changes are made, reset the printer. Once the printer has been reset, allow approximately 
two minutes for the printer to go through a self test, then log onto the network server.

Print out another copy of the “Configuration Page” to verify that the items you modified 
were set and kept.