Gestetner c7528 操作ガイド
Monitoring and Configuring the Printer
268
❒ For details about UNIX commands and parameters, see UNIX Supplement.
❒ For details about “syslog” command, see
❒ For details about “syslog” command, see
Snmp over ip is ready.
Communication over TCP/IP with snmp is
available.
available.
Snmp over IP over 1394 is ready.
Communication over IP over 1394 with snmp
is available.
is available.
Snmp over ipx is ready.
Communication over IPX with snmp is avail-
able.
able.
account is unavailable:
Same account name be used.
User account is disabled. This could be be-
cause it use the same account name as the
administrator account.
cause it use the same account name as the
administrator account.
account is unavailable:
The authentication password is not set up.
User account is disabled. This could be be-
cause the authentication password is not set,
and only the encryption account is set.
cause the authentication password is not set,
and only the encryption account is set.
account is unavailable:
encryption is impossible.
Encryption is not possible and account is dis-
abled. This could be because:
abled. This could be because:
•
Security option is not installed.
•
Encryption password has not been speci-
fied.
fied.
trap account is unavailable.
v3Trap cannot be sent. This could be because
the Trap destination account is different from
the account specified by the printer.
the Trap destination account is different from
the account specified by the printer.
snmpd start.
The snmpd service has started.
started.
The direct print service has started.
Started.
The rendezvous function is enabled.
Terminated.
The rendezvous function is disabled.
The print server received error <error number>
during attempt to log in to the network. Access
to the network was denied. Verify that the print
server name and password are correct.
during attempt to log in to the network. Access
to the network was denied. Verify that the print
server name and password are correct.
Login to the file server failed. The print server
is not registered or a password is specified.
Register the print server without specifying a
password.
is not registered or a password is specified.
Register the print server without specifying a
password.
usbd is disabled.
Plug and Play function and printing is disabled
because usbd is disabled in the security mode.
because usbd is disabled in the security mode.
Enable usbd in the security mode.
WINS wrong scopeID=<scope ID>
The scope ID is incorrect.
Specify the correct scope ID.
WINS name registration: No response to serv-
er(WINS server sddress)
er(WINS server sddress)
There was no response to the registration re-
quest from the server. Check that the WINS
server address is correct and the WINS server
is working properly.
quest from the server. Check that the WINS
server address is correct and the WINS server
is working properly.
Message
Problem and solutions