Gestetner f104 操作ガイド
Transmission Features
61
3
BBBB
Press the Quick Dial key the Auto
Document is stored in.
The message “
Document is stored in.
The message “
Retrieved Auto
Doc.
” appears on the display and
then the standby display reap-
pears.
pears.
CCCC
Specify the destination.
DDDD
Press the
{{{{Start}}}} key.
No Document, No Dial
If you dial a destination fax number
and for some reason take your docu-
ment back to your desk and another
person places a different document,
their document could be sent to the
wrong destination. To avoid such
mistakes, when this feature is turned
on, you cannot dial a destination un-
less your document is set.
and for some reason take your docu-
ment back to your desk and another
person places a different document,
their document could be sent to the
wrong destination. To avoid such
mistakes, when this feature is turned
on, you cannot dial a destination un-
less your document is set.
Note
❒ The standby display when this fea-
ture is turned on.
❒ This feature is turned off by de-
fault. If you want to turn this fea-
ture on, please contact your service
representative.
ture on, please contact your service
representative.
Blank Sheet Detect
This feature is designed to help you
avoid making mistakes while scan-
ning documents.
If you try and scan in an almost com-
pletely blank original, an alarm
sounds and the following display ap-
pears. Make sure the original is not
blank.
avoid making mistakes while scan-
ning documents.
If you try and scan in an almost com-
pletely blank original, an alarm
sounds and the following display ap-
pears. Make sure the original is not
blank.
Limitation
❒ This feature is not supported in
copier mode.
Note
❒ Transmission is not cancelled even
if the machine detects the original
is blank.
is blank.
❒ With Memory Transmission, the
alarm sounds as soon as the origi-
nal has been scanned. To cancel the
t r a n s m i s s i o n , p r e s s t h e
nal has been scanned. To cancel the
t r a n s m i s s i o n , p r e s s t h e
{{{{Clear/Stop}}}} key while the “
Some
Page(s) are Blank
” is appears
on the display.
❒ You can turn Blank Sheet Detect on
or off with the User Parameters.
See p.146 “User Parame ters”
(switch 11, bit 2).
See p.146 “User Parame ters”
(switch 11, bit 2).
StellaF2_EN_Combine_F_FM.book Page 61 Friday, February 14, 2003 5:16 PM