ONKYO HT-S8400 ユーザーズマニュアル

En

■

`

`

Yes:

Zone 2 speakers can be used. (Powered Zone 2 
enabled).

• Before you change this setting, turn down the volume.
• When the “Powered Zone 2” setting is set to “Yes”, the 

surround back or front high speakers cannot be used.

With these settings, you can specify which speakers are 
connected and a crossover frequency for each speaker. 
Specify “Full Band” for speakers that can output low 
frequency bass sounds adequately, for example, speakers 
with a good sized woofer. For smaller speakers, specify a 
crossover frequency. Sounds below the crossover 
frequency will be output by the subwoofer instead of the 
speaker. Refer to your speaker’s manuals to determine the 
optimum crossover frequencies.

• These settings are not available in either of the following cases:

– a pair of headphones is connected.
– the  “Audio TV Out” setting is set to “On” (

page 52).

– “HDMI Control (RIHD)” is set to “On” (

you’re listening through your TV speakers.

■

`

`

■

`

`

40Hz to 100Hz, 120Hz, 150Hz, 200Hz

• If  the  “Subwoofer” setting is set to “No”, the “Front” setting is 

fixed to “Full Band”.

■

*1

*1

*2*3*4*5

`

`

40Hz to 100Hz, 120Hz, 150Hz, 200Hz

`

■

*1*2*4*6

`

`

40Hz to 100Hz, 120Hz, 150Hz, 200Hz

`

*1

“Full Band” can be selected only when “Full Band” is 
selected in the “Front” setting.

*2

If the “Surround” setting is set to “None”, this setting cannot 
be selected.

*3

If the “Surround” setting is set to anything other than “Full 
Band”, “Full Band” cannot be selected here.

*4

If the “Powered Zone 2” setting is set to “Yes”, this setting 
cannot be selected.

*5

If anything else than “None” is selected in “Front High”, this 
setting is automatically set to “None”.

*6

If anything else than “None” is selected in “Surround Back”, 
this setting is automatically set to “None”.

■

`

1ch:

Select if only one surround back speaker L is 
connected.

`

2ch:

Select if two (left and right) surround back speakers 
are connected.

• If  the  “Surround Back” Setting is set to “None”, this setting 

cannot be selected.

■

`

80Hz, 90Hz, 100Hz, 120Hz

`

Bypass:

Low-Pass Filter is not applied.

With this setting, you can specify the cutoff frequency 
of the LFE channel’s low-pass filter (LPF), which can 
be used to filter out unwanted hum. The LPF only 
applies to sources that use the LFE channel.