ONKYO ht-r500 取り扱いマニュアル

14

Insert one end of the AM antenna cord to either of the AM antenna connectors and the other end to the other connector. There is no difference
between one end of the AM antenna cord and the other end, unlike the speaker cables which have positive and negative poles.

The AM loop antenna is for indoor use only. Set it in the direction and position where you receive signals clearly. Put it as far away as
possible from the HT-R500, televisions, speaker cables, and power cords.

When reception is not satisfactory with the attached AM loop antenna alone, connection of an outdoor antenna is recommended.

Insert into the
hole.

Rotate the outer frame
of the antenna.

Extend the
antenna cord.

Press up and hold
the lever.

Insert the end of the
cord.

Release the lever to
secure the connection.

The FM indoor antenna is for indoor use only. During use, extend the antenna and move it in various directions until the clearest signal is
received. Fix it with push pins or similar implements in the position that will cause the least amount of distortion.

If the reception is not very clear with the attached FM indoor antenna, the use of an outdoor antenna is recommended.

1

Strip away the insulation from
the end of the cord.

2

Fully insert the stripped end of
the cord.