TallyGenicom 3860 クイック設定ガイド
GEK-01054
18
Find the ribbon drive spindle.
Look down into the printer toward the left side and notice a small shaft
sticking up vertically through a shiny plate.
sticking up vertically through a shiny plate.
Seat the cartridge on the ribbon drive spindle.
Place the cartridge down in the printer about where it should go and slide
it around until the ribbon drive spindle slips up into the hub of the
cartridge. Turn the ribbon advance knob clockwise and feel the ribbon
drive gears turning in the printer.
it around until the ribbon drive spindle slips up into the hub of the
cartridge. Turn the ribbon advance knob clockwise and feel the ribbon
drive gears turning in the printer.
Snap the ribbon cartridge down on the supports.
There are feet on the bottom of the cartridge at the front corners. These
snap onto corresponding feet in the printer. Gently push the front corners
of the cartridge down at both ends until the snaps snap into place.
snap onto corresponding feet in the printer. Gently push the front corners
of the cartridge down at both ends until the snaps snap into place.
Turn the ribbon advance knob clockwise to make sure the ribbon is taut.
Hub
Rear of Cartridge
Ribbon Drive Spindle
Ribbon
Advance
Knob
Support
Foot
Adjusting the Ribbon Advance Knob