Samsung NX10 ユーザーガイド
5
Using the OIS in the menu option
After setting the OIS switch, select the OIS function in
the menu option
the menu option
1
In Shooting mode, press [MENU].
2
Select Shooting3 (
3
/
3
) → OIS →
an option.
OIS
Mode 1
The OIS function is applied only when
pressing the shutter in full or half.
pressing the shutter in full or half.
OIS
Mode 2
The OIS function is always applied.
The OIS function may not be applied well in the
following cases.
following cases.
When taking a picture while tracing a moving
object
When a big vibration occurs beyond the range of
stabilization
When the shutter speed is too slow due to a
circumstance like night shooting
When the battery capacity is not sufficient
When having a close-up shot
object
When a big vibration occurs beyond the range of
stabilization
When the shutter speed is too slow due to a
circumstance like night shooting
When the battery capacity is not sufficient
When having a close-up shot
When using a tripod, please disable the OIS function
since the image can be shaken due to the vibration
of OIS function.
If the camera is shocked when taking a picture, the
display can be shaken. In this case, the camera may
operate normally if the camera is powered off and
on again.
Since the battery consumption can increase along
with the use of OIS function, it is recommended to
use the function only if needed.
To set the OIS function by using the menu, set
[OIS] of lens to ON. This function may not operate
depending on the lens model.
The function can be set directly by pressing [Fn] in
the shooting mode.
since the image can be shaken due to the vibration
of OIS function.
If the camera is shocked when taking a picture, the
display can be shaken. In this case, the camera may
operate normally if the camera is powered off and
on again.
Since the battery consumption can increase along
with the use of OIS function, it is recommended to
use the function only if needed.
To set the OIS function by using the menu, set
[OIS] of lens to ON. This function may not operate
depending on the lens model.
The function can be set directly by pressing [Fn] in
the shooting mode.
•
-
-
-
-
-
-
•
•
•
•
•