Samsung pl-42s5 ユーザーガイド

37

Your TV can memorize and store all of the available channels for both “off-air” (antenna) and cable
channels. After the available channels are memorized, use the CH

and CH

buttons to scan

through the channels. This eliminates the need to change channels by entering the channel digits.
There are three steps for memorizing channels: selecting a broadcast source, memorizing the
channels (automatic) and adding and deleting channels (manual).

Selecting a broadcast source

Before your television can begin memorizing the available channels, you must specify the type of signal
source that is connected to the TV (i.e., an antenna or a cable system).

1

Press the MENU button. Press the 

▲ or ▼ button to select

“Channel”, then press the ENTER button.

2

Press the ENTER button to select “Air/Cable”.

3

Press the 

▲ or ▼ button to select  “Air”, “STD”, “HRC”

or “IRC”, then press the ENTER button. 

• If you are connected to an antenna, leave “Air” 

displayed. If you connected cable, press the 

▲ or ▼

button to display the type of cable system: “STD”, 
“HRC” or “IRC”.
(If you are not sure which type of cable system you 
have, contact your cable company).

4

Press the EXIT button to exit.

• STD, HRC and IRC identify various types of cable TV systems. Contact your local cable company to

identify the type of cable system that exists in your particular area. At this point the signal source
has been selected. Proceed to “Storing Channels in Memory” (Next page).

√

√

√

√

√

BN68-00866C-00Eng(032~043)  8/4/05  6:18 PM  Page 37