Infocus LP500 参照ガイド
14
S
e
t
t
i
n
g
u
p
t
h
e
P
r
o
j
e
c
t
o
r
Powering up the Projector
NOTE: Always use the power cord
that shipped with the projector.
1
Remove the lens cap.
2
Plug the power cord into the side of the projector, then plug it
into your electrical outlet. A surge-protected power strip is
recommended.
into your electrical outlet. A surge-protected power strip is
recommended.
•
The LED on the top of the projector (Figure 17 on page 22)
lights green.
lights green.
3
Turn on the lamp by pressing the green
power
button on the
keypad or remote.
•
A tone sounds when you press the button, and the LED
blinks green while the software initializes. When initializa-
tion is complete, the LED lights solid green and the InFocus
startup screen appears.
blinks green while the software initializes. When initializa-
tion is complete, the LED lights solid green and the InFocus
startup screen appears.
4
If you connected a video player, turn it on.
•
The video image should display on the projection screen. If
it doesn’t, press the
it doesn’t, press the
source
button on the keypad or the
video
button on the remote to display your video image.
You can select a default source to determine which source
the projector examines first during power-up for active
video; see “Default Source” on page 42.
the projector examines first during power-up for active
video; see “Default Source” on page 42.
•
Use the
volume
buttons to adjust the volume.
5
Turn on your computer.
For Windows 98:
a
The first time you connect a particular computer to the pro-
jector, the computer recognizes the projector as “new hard-
ware” and the Add New Hardware Wizard appears.
Follow these instructions to use the Wizard to load the cor-
rect driver (which was installed with your Windows oper-
ating system).
jector, the computer recognizes the projector as “new hard-
ware” and the Add New Hardware Wizard appears.
Follow these instructions to use the Wizard to load the cor-
rect driver (which was installed with your Windows oper-
ating system).