Infocus TD30 仕様ガイド

 

Remote control of the TD30 display is managed via commands sent over the serial (RS-232) port. 
 
The serial port should be configured as follows: 
 

Baud Rate: 19200 
Parity: None 
Data bits: 8 
Stop bits: 1 
Flow Control: None 

 
To connect to the product the following 11-byte sequence must be sent to the serial port: 
 

0xBE 0xEF 0x10 0x04 0x00 0x60 0x9e 0x5a 0xa5 0x00 0x00  

 
Once connected to the product various settings within the product can be changed using six-byte command 
sequences in the form of: 
 

SL CM0 CM1 CM2 CM3 CS 

 
Where each element has the following meaning: 
 

SL: Slave Address  
CM0:  Command Follows 
CM1:  Command Group 
CM2:  Command Function 
CM3:  Command Data 
CS: Checksum = CM0^CM1^CM2^CM3 (logical XOR of all four command bytes) 

 
See the table below for a list of the available command sequences and their function. 
 
To disconnect from the product the following 6-byte sequence must be sent to the serial port: 
 

0xC0 0x53 0x5A 0x00 0x00 0x09 

 

0xC0 0x53 0x16 0x01 0x00 0x44 Reset 

NVRAM 

0xC0 0x53 0x16 0x02 0x00 0x47 Select Analog RGB Source 
0xC0 0x53 0x16 0x03 0x00 0x46 Select Digital RGB Source 
0xC0 0x53 0x16 0x04 0x00 0x41 Select S-Video Source 
0xC0 0x53 0x16 0x05 0x00 0x40 Select 

HDTV 

Source 

0xC0 0x53 0x16 0x06 0x00 0x43 Select Composite1 Source 
0xC0 0x53 0x16 0x07 0x00 0x42 Select Composite2 Source 
0xC0 0x53 0x16 0x08 0x00 0x4D Select TV Source (Tuner Input) 
0xC0 0x53 0x16 0x09 0x00 0x4C 

Select Component Source 

0xC0 0x53 0x17 0x00 0x00 0x44 Save 

Data 

0xC0 0x53 0x18 0x00 0x00 0x4B 

Set Color Temp 9300K 

0xC0 0x53 0x18 0x01 0x00 0x4A 

Set Color Temp 6500K 

0xC0 0x53 0x18 0x03 0x00 0x48 

Set Color Temp 5000K 

0xC0 0x53 0x18 0x17 0x00 0x5C Save 

Data 

0xC0 0x53 0x23 0x00 0x00 0x70 Power 

On 

0xC0 0x53 0x24 0x00 0x00 0x77 Power 

Off 

0xC0 0x53 0x5A 0x00 0x00 0x09 Disconnect from TD30