Infocus IN32 補足マニュアル

•

Be extremely careful when removing the lamp housing. In the unlikely 
event that the lamp ruptures, small glass fragments may be generated. 
The lamp module is designed to contain most of these fragments, but 
use caution when removing it. Before replacing a ruptured lamp, clean 
the lamp compartment and dispose of cleaning materials. Wash hands 
after lamp replacement. This product has a lamp which contains a very 
small amount of mercury. Dispose of it as required by local, state or fed-
eral ordinances and regulations. For more information see 
www.eiae.org

.

Detach the lamp connector from the projector by gently pulling the con-
nector until it is disconnected from the projector.

Carefully remove the lamp module by grasping and lifting the metal 
bail wire. Dispose of the lamp in an environmentally proper manner. 

Install the new lamp module, making sure that it is properly seated. Be 
careful not to touch the interior components of the projector.

Snap the bail wire back into its flat position against the lamp module.

Re-attach the lamp connector to the projector. Make sure the connector is 
fully inserted.

Tighten the screw on the lamp module.

Replace the lamp door.

Plug in the power cable then press the Power button to turn the projec-
tor back on, then reset the lamp hour timer. 

To reset the lamp timer, navigate to the Settings>Service menu and select 
Reset

 Lamp Hours. 

disconnect lamp connector

remove module using bail wire

reset lamp time in Service menu