Infocus IN2102 ユーザーズマニュアル

: turns the image upside down for ceiling-mounted projec-

tion.

: reverses the image so you can project from behind a translu-

cent screen.

 PC Screen Saver: prevents your computer from going into Screen 

Save mode. The projector must be connected to the PC via a USB cable for 
this feature to work.

allows you to display a blank screen instead of the default 

screen at startup, and when no source is detected. 

 captures the current image and allows it to be used as the 

startup screen image. 

: determines what color is displayed when you press 

the Blank button on the remote.

: Select Solid, Timer, or Test Patterns. The Timer option 

is useful for classroom tests or break times during meetings.

: displays status messages (such as “Searching”) in the 

lower-left corner of the screen.

allows you to change the position of the On Screen Display 

items.

allows you to change how much of the projected 

image behind the menu you can see. As the value increases, more of the 
image behind the menu is visible.

allows you to change the function of the arrow buttons 

when the menu is not shown. By default, the arrow buttons allow you to 
advance slides while in PowerPoint’s SlideShow mode. To make the arrow 
buttons also adjust magnify settings, choose Magnify Controls to turn mag-
nify controls on. Now when the menu is not shown, you can press the Select 
button to switch between the magnification settings (Magnify Level, Mag-
nify Horizontal Position and Magnify Vertical Position), then press Select 
again to turn off magnify controls and use the arrow buttons to advance 
slides.

The PIN (personal identification number) feature allows you 

to password protect your projector. Once you enable the PIN feature, you 
must enter the PIN before you can project an image. The default PIN on this 
projector is Menu-Arrow Up-Arrow Down-Select-Source. Use the naviga-
tion buttons on the remote or keypad to enter the correct 5-button press 
sequence. When all 5 numbers are entered correctly, press the Select button 
on the remote or keypad to select OK. If the message “Wrong PIN” appears, 
verify the code and re-enter it. If you mis-enter a number, you must enter 5 
numbers and press the Select button in order to access the “Wrong PIN” 
message and re-enter the code.

Power up the projector. The “Enter PIN” dialog box appears after the star-
tup screen. Enter the PIN. Use the navigation buttons on the remote or key-
pad to enter the correct button press sequence. See the description above for 
instructions. 

Select “Change PIN...” in the Setup menu. Enter the existing PIN. Enter the 
new PIN. You can navigate between OK and Cancel by pressing the up and 
down buttons on the keypad. Select OK or Cancel by pressing the Select 
button. Verify the new PIN.

Call InFocus Technical Support. 

Selects the serial port and baud rate.

Controls whether the serial port echoes characters.