Infocus XS1 参照ガイド

Operation

22

1.

Plug the power cord into the projector and 
into a wall socket. Turn on the wall socket 
switch (where fitted). Check that the Power 
indicator on the projector lights orange after 
power has been applied.

2.

Remove the lens cover. If it is left on, it 
could become deformed due to the heat 
produced by the projection lamp.

3.

Press 

Power on the projector or remote 

control to start the projector. The Power 
indicator light flashes green and stays 
green when the projector is on.
The start up procedure takes about 30 
seconds. In the later stage of start up, a 
startup logo is projected.
(If necessary) Rotate the focus ring to 
adjust the image clearness.

4.

If you are prompted for a password, press 
the arrow buttons to enter a six digit 
password. See 

 for details.

5.

Switch all of the connected equipment on.

6.

The projector will start to search for input signals. The current input source 
being scanned displays on the screen. If the projector doesn't detect a valid 
signal, the 'No Signal' message will continue displaying until an input source 
signal is found.
You can also press SOURCE on the projector or remote control to select your 
desired input signal. See 

 for details.

PUSH