Infocus LP280 ユーザーズマニュアル

Powering up the Projector

NOTE: Always use the power cord

that shipped with the projector.

Remove the lens cap.

Plug the power cord into the back of the projector, then plug it
into your electrical outlet. A surge-protected power strip is
recommended.

•

The LED on the top of the projector (Figure 11 on page 18)
lights orange after a few seconds.

After the LED lights orange, press the Power button on the
projector’s keypad or remote.

NOTE: The first time you connect

your computer to the projector, the

computer may display a message

stating that new hardware was

found. The Add New Hardware

Wizard may appear. Use the Wiz-

ard to load the correct driver (the

computer considers the projector a

Plug and Play Monitor).

•

The fans start to run, the LED on the top of the projector
lights green, and the InFocus startup screen appears. It
takes about one minute for the image to achieve full bright-
ness.

If you connected a video player, turn it on.

•

The video image should display on the projection screen. If
it doesn’t, press the

Source/Select

button on the keypad

(page 18) or the

Video

button on the remote to display your

video image.

If you connected a computer, turn it on.

•

The computer image should display on the projection
screen. If it doesn’t, press the

Source/Select

button on the

keypad or the

Computer

button on the remote to display

your computer’s image.

NOTE: With some computers,

the order in which you power up

the equipment is very important.

Most computers should be turned

on last, after all other peripherals

have been turned on. Refer to your

computer’s documentation to

determine the correct order.

•

Make sure your laptop’s external video port is activated;
see “Portable and Laptop Activation Chart” on page 42 for
details.

•

If necessary, make adjustments to the image using the pro-
jector’s on-screen menus. To open the menus, press the

Menu

button on the keypad or remote. For more informa-

tion about the menus, see page 21.