Infocus lp630 インストール手順

 

 

q 

Place warning label on lamp door where indicated. Invert the 

projector and place it on a soft and flat surface. 

Locate the four (4) 4 (mm) mounting points found on the bottom 

of the projector. Secure the three (3) Quick release sleeves (D) 
with the three (3) 4 (mm) x 16 (mm) Phillip Screws (C)  

(supplied). Align the keyhole openings from the mounting 

bracket (B) to the sleeves (D) and secure the bracket with the 

 4 (mm) x 12 (mm) knurl knob (A) (supplied). Do not over 

tighten!  
See Figure 1  

 

 
 

 
 
 

 
 

 
 

 
 
 

 
 

 
 

 
 
 

 
 

 
 

 
  
 

q 

Install the base box securely to the ceiling structure in 

accordance with proper commercial standards. Use 
(commercially available) suitable hardware depending on the 

installation requirements.  

 

 
 

 

If the (Optional) SP-LTMT-EXT adjustable height 

suspension adapter is a part of the installation, securely install 

the ceiling adapter to the ceiling at this time.

 

 

 
 

 
 

 
 
 

 
 

 
 

 
 
 

 
 

 
 

 
 
 

 
 

 
 

 
 
 

 
 

 
 

 
 

 
 
 

 
 

 
 

 
 

 
 

 
 

q 

Install the two (2) conical spacers (J) and two (2) flat washers (K), two 
(2) hinge screws (L) loosely on both sides of the base box (H). Raise 
the projector with the mounting bracket attached and slip t hough the 
hinge pin slots openings on the bracket into the base box. Install the 
two (2) angle locking screws (I) adjust the angle, lock it, and then 
tighten the hinge pin screws. 
See Figure 2 

 
 

 

 

 
 

 
 
 

 
 

 
 

 
 
 

 
 

 

q 

Check all the hardware for proper tightness and security. Do not 
over tighten hardware. 

 

PORTABLE PROJECTORS  

 

(1)  Remove the knurl knob screw and hold the projector with 

two hands.  

(2)  Slide it backwards to detach the sleeves from the keyholes.  
(3)  Reverse the process for quick reinstall.