Infocus LP70+ ユーザーガイド
11
Powering up the Projector
NOTE: Always use the power cord
that shipped with the projector.
1
Remove the lens cap.
2
Plug the power cord into the side of the projector, then plug it
into your electrical outlet. A surge-protected power strip is
recommended.
into your electrical outlet. A surge-protected power strip is
recommended.
•
The LED turns orange (Figure 6 on page 6).
3
Press the
Power
button on the top of the projector.
NOTE: The first time you connect
your computer to the projector, the
computer may display a message
stating that new hardware was
found. The Add New Hardware
Wizard may appear. Use the Wiz-
ard to load the correct driver (the
computer considers the projector a
Plug and Play Monitor).
•
The fans start to run, the LED on the top of the projector
(Figure 6 on page 6) lights solid green if the projector is con-
nected to a valid source, and the startup screen appears. It
takes about one minute for the image to achieve full bright-
ness.
(Figure 6 on page 6) lights solid green if the projector is con-
nected to a valid source, and the startup screen appears. It
takes about one minute for the image to achieve full bright-
ness.
4
If you connected to a video player, turn it on.
•
The video image should display on the projection screen. If
it doesn’t, press the
it doesn’t, press the
Source/Select
button on the keypad or
the
Video
button on the remote to display your video
image.
5
If you connected to a computer, turn it on.
The first time you connect a particular computer to the projec-
tor, the computer recognizes the projector as “new hardware”
and the Add New Hardware Wizard appears. Follow these
instructions to use the Wizard to load the correct driver (which
was installed with your Windows operating system).
tor, the computer recognizes the projector as “new hardware”
and the Add New Hardware Wizard appears. Follow these
instructions to use the Wizard to load the correct driver (which
was installed with your Windows operating system).
Click Next. Make sure “Search for the best driver” is selected,
then click Next.
then click Next.
LP70.book Page 11 Friday, February 13, 2004 7:39 AM