Infocus LP790 参照ガイド

Page 5

6 ERROR SYNTAX

If an command isn’t available the projector response with an error message:

|------------------------------------ Error message ----------------------------------|

ASCII

HEX

DEC

Comment

Error is always started with an Error Mark

Table 5

The following error codes are defined:

1000;<Unknown command>
1001;<Unknown parameter>
1002;<Parameter out of range>
1003;<Command not supported by this projector>
1004;<Command only available in Power on>
1005;< Projector not ready to be turned on>
1006;<Command only available with valid input source>
1007;<Command only available with external module>
1008;<Command failed>
2000;<Command only available in RGB>
2001;<Command only available in VIDEO>
2002;<Command only available in NTSC>

6.1 Error Example

ASK>BRX;50

↵

<Error Mark> <(Command)> <ErrorCode> <Separator> <<ErrorString>>
! (BRX;50) 1000 ; <Unknown command