Infocus LP770 参照ガイド
36
M
a
i
n
t
e
n
a
n
c
e
&
T
r
o
u
b
l
e
s
h
o
o
t
i
n
g
Problem: Image is too wide or narrow for screen
•
Adjust the zoom or projector placement.
•
Adjust the resolution of your video card if it’s greater than
1280x1024.
Problem: Image is out of focus
•
Use the
Focus/Zoom
button to focus the image.
•
Make sure the projection screen is at least 5 feet (1.5 m) from
the projector.
•
Check the projection lens to see if it needs cleaning.
Problem: Image and menus are reversed left to right
•
Rear projection mode is probably selected. Turn Image
Reverse off in the Installation menu. The image should imme-
diately return to forward projection. See “Image Reverse” on
page 24
diately return to forward projection. See “Image Reverse” on
page 24
Problem: the projector displays vertical lines, “bleeding” or
spots
spots
•
Adjust the brightness. See “Brightness” on page 21
•
Check the projection lens to see if it needs cleaning.
Problem: no sound
•
Adjust volume.
•
Verify audio/input connections.
•
Adjust audio source.
•
Make sure Mute is not active.
Problem: Image is “noisy” or streaked
Try these steps in this order.
Try these steps in this order.
1
Deactivate the screen saver on your computer.
2
Adjust the synchronization and tracking manually to find an
optimal setting. See “Fine Sync” on page 27 and “Tracking” on
page 28.
optimal setting. See “Fine Sync” on page 27 and “Tracking” on
page 28.
•
The problem could be with your computer’s video card. If
possible, connect a different computer.