Infocus IN15 ユーザーガイド
21
Troubleshooting
En
gl
is
h
Try performing the following steps, which can return the projector to normal operation.
1. Press the [
1. Press the [
] (power) key to turn off the projector.
2. After the projector’s cool down is finished and the fan is completely stopped, unplug the
AC power cord.
3. Plug the power cord back in and turn the projector back on again.
* If the power off confirmation message does not appear when you press the [
]
(power) key, unplug the AC power cord and wait for at least 10 minutes. Then plug
the power cord back in and turn the projector back on again.
the power cord back in and turn the projector back on again.
The message “It is
time to replace the
lamp.” is being
projected.
time to replace the
lamp.” is being
projected.
It is time to replace the lamp.
➔ Replace the lamp (see “Replacing the Lamp”).
Reference
Guide
(CD-ROM)
The message “The
lamp has exceeded
its service life!.” is
being projected.
lamp has exceeded
its service life!.” is
being projected.
The allowable life for the lamp has been exceeded,
and the projector will not turn on.
and the projector will not turn on.
➔ Replace the lamp (see “Replacing the Lamp”).
Reference
Guide
(CD-ROM)
Problem
Cause and Recommended Action
See
Infocus IN15_UG_E.book Page 21 Tuesday, October 23, 2007 5:37 PM