OCZ Technology neutrino インストール手順
Preparing / Replacing the Hard Disk Drive
02
The OCZ Neutrino Netbook uses a Serial ATA interface, therefore, any 2.5” mobile HDD/SSD selected for
this system needs to comply with the SATA standard. The HDD drive bay is located underneath the
access panel. Carefully remove the two remaining screws marked by the short arrows as shown below,
the screw marked by the long arrow was already removed earlier in the process of removing the access
panel.
this system needs to comply with the SATA standard. The HDD drive bay is located underneath the
access panel. Carefully remove the two remaining screws marked by the short arrows as shown below,
the screw marked by the long arrow was already removed earlier in the process of removing the access
panel.