ICOM ic-2100h 取り扱いマニュアル
15
4
SETTING A FREQUENCY
■
Using the tuning dial
➀
Rotate the tuning dial to set the frequency.
• If VFO mode is not selected, push [V/MHz] to select VFO mode.
• The frequency changes according to the selected tuning steps.
(p. 16)
➁
To change the frequency in 1 MHz (10 MHz for some ver-
sions) steps, push [V/MHz], then rotate the tuning dial.
sions) steps, push [V/MHz], then rotate the tuning dial.
• Pushing [V/MHz] for 1 sec. starts a scan function. If this happens,
push [V/MHz] again to stop the scan.
■
Using the [
Y
]/[
Z
] keys
Push [
Y
] or [
Z
] to select the desired frequency.
• If VFO mode is not selected, push [VFO] to select it.
• The frequency changes according to the selected tun-
ing steps. (p. 16)
• Pushing [
Y
] or [
Z
] for more than 0.5 sec. activates a
scan. If this happens, push [
Y
] or [
Z
] again to cancel
the scan.
☞
NOTE: 1 MHz steps cannot be used via the [
Y
]/[
Z
] keys.
9
5
1
The display shows that the 1 MHz
tuning step is selected.
tuning step is selected.
YZ