ICOM ic-f1020 取り扱いマニュアル

■

q

Push

[K

I

] 

to turn the power ON.

• A power-up alert tone sounds for

about 1 sec. and an opening mes-
sage may appears.

w

If the transceiver is programmed
for start up passcode, input digit
codes as directed by your sys-
tem operator.

• The following keys can be used for

the password input:

•

The transceiver detects the numbers in the same block as the
same number.  Therefore the same effect for “1234” and “6789.”

e

When the “PASSWORD” indication does not clear after 4-
digit input, the input code number may be incorrect.  Turn
power off and start over in this case.

■

There are several types are available, and channel selection
method may differ according to your system:

NON-BANK TYPE:
Push the [

] or [

] keys to select the desired oper-

ating channel, in sequence; or,
push one of the [

] to [

] keys to select these channels

directly.

q

Push [

], then push [

] or [

] to select the de-

sired bank number; or
Push [

] or [

] if the

transceiver has these keys.

w

Push [

] or [

] to select

the desired channel in the selected bank.

AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type.  When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or taking the micro-
phone off from the microphone hanger.

2

6

Opening message may 
differ depending on the 
pre-setting.

Input your password if 
this display appears.

Bank number

0
5

1
6

2
7

3
8

4
9