ICOM IC-V8000 取り扱いマニュアル

■ Offset frequency

When communicating thorough a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.

q Push [SET(LOCK)] to enter set mode.
w Push [SET(LOCK)] or [MW(S.MW)] until “±” and offset fre-

quency appear.

e Rotate the tuning dial to set the desired offset frequency.
r Push [TONE(T-SCAN)] to exit set mode.

z Push [

SET

B(D-OFF)] to enter set mode.

x Push [

SET

B(D-OFF)] or [

ENT

C(T-OFF)] until “±”

and offset frequency appear.

c Push [Y] or [Z] to set the desired offset.

• Direct frequency entry from the keypad is not possi-

ble.

v Push [

CLR

A(MW)] to exit set mode.

■ Repeater lockout

This function helps prevent interference to other stations by
inhibiting your transmission when a signal is received. The
transceiver has two inhibiting conditions, repeater and busy.

q Push [PWR] to turn power OFF.
w While pushing [SET(LOCK)], turn power ON to enter initial

set mode.

e Push [SET(LOCK)] or [MW(S.MW)] several times until the

“RLO” display appears as shown below.

r Rotate the tuning dial to turn the repeater lockout function

to “RP,” “BU” or OFF.

• “RP”: Transmit is inhibited when a signal with un-matched sub-

audible tone is received.

• “BU”: Transmit is inhibited when a signal is received.

t Push [PWR] to exit initial set mode.

Repeater lockout function is
turned OFF.

Repeater lockout function is
turned ON.

While pushing [SET(LOCK)],
turn power ON.

USING

INITIAL SET MODE

Push

SET

[SET(LOCK)]

USING

SET MODE

REPEATER OPERATION