ICOM IC-V8000 取り扱いマニュアル

30

5

MEMORY OPERATION

■ Programming channel names 

Each memory channel and the call channel can be pro-
grammed with an alphanumeric channel name for easy
recognition and can be indicated independently by channel.
Names can be a maximum of 6 characters— see the table
below for available characters.

q Push [M/CALL(PRIO)] to select memory mode.
w Rotate the tuning dial to select the desired memory channel.
e Push [MONI(ANM)] for 1 sec. to select channel name in-

dication mode.

• 1 short and 1 long beep sound.

r Push [SET(LOCK)] to select the channel name program-

ming condition.

• Frequency readouts disappear.

t Rotate the tuning dial to select the desired character.

• The selected character blinks.

y Push [SET(LOCK)] or [MW(S.MW)] to move the cursor to

left or right, respectively.

u Repeat steps t and y until the desired channel names

are displayed.

i Push [V/MHz(SCAN)] to program the name and exit the

channel name programming condition.

o Push [MONI(ANM)] for 1 sec. to return to frequency indi-

cation if desired.

Once channel name indication mode is

selected, always access the channel name programming
condition when [SET(LOCK)] is pushed. 
When set mode accessing is necessary, cancel the chan-
nel name indication by pushing [MONI(ANM)] for 1 sec.,
then access to set mode.

(1)

(B)

(L)

(V)

(+)

(2)

(C)

(M)

(W)

(–)

(3)

(D)

(N)

(X)

(=)

(4)

(E)

(O)

(Y)

(

✱)

(5)

(F)

(P)

(Z)

(/)

(6)

(G)

(Q)

(space)

(7)

( ( )

(H)

(R)

( ) )

(8)

(I)

(S)

(|)

(9)

(J)

(T)

(0)

(A)

(K)

(U)

[EXAMPLE]: Programming “CLUB” into memory channel 1.

Push           .

Select memory channel 1, 
then push        for 1 sec.

Push         or         to move 
the cursor.

Rotate        to select the 
character.

Repeat

previous

steps.