ICOM id-rp2 取り扱いマニュアル
31
5
DRIVER INSTALLATION
■ COM port confirmation
After the driver installation, confirm the driver availabil-
ity and the port number are recommended.
In this section, COM port number confirmation of the
ID-RP2C [SERVICE1] connector is used for instruction
example.
ity and the port number are recommended.
In this section, COM port number confirmation of the
ID-RP2C [SERVICE1] connector is used for instruction
example.
D
D Microsoft
®
Windows
®
XP/2000
q Start up Windows.
w Connect the PC and the ID-RP2C [SERVICE1] con-
w Connect the PC and the ID-RP2C [SERVICE1] con-
nector through an USB cable
(A-B type; purchase
separately)
.
e Right click “My Computer” then select “Properties.”
• “My Computer” is available in <Start> menu with Win-
dows XP.
r “System Properties” screen appears as at left.
Click [Hardware] tub and then click [Device Man-
ager].
ager].
t “Device Manager” screen appears.
Click “
” of Ports (COM&LPT).
y Confirm “ICOM ID-RP2C SERVICE1 (COM
✱)” is
displayed.
• If not displayed, or few COM port numbers are displayed
at the same time, the driver installation may not be in-
stalled properly. Un-install the USB driver then re-install
the driver again in such cases.
stalled properly. Un-install the USB driver then re-install
the driver again in such cases.
NOTE: “
✱” is the COM port number, that is used
for the communication setting with the utility soft-
ware.
ware.
<e.g.: When driver re-installation is required>
“ICOM ID-RP2C SERVICE1 (COM
✱) (COM✱)”
Check the connected unit and connector names,
and COM port number.
(In this example, the USB serial port number is “3.”)
and COM port number.
(In this example, the USB serial port number is “3.”)
Click
Click
Click