Olympus C-160 クイック設定ガイド

ページ / 2
J-1121-929 D4210  D-395/C-160 QSG En_
オモテ   PANTONE287
J-1121-929 D4210  D-395/C-160 QSG En_
オモテ スミ 
DC IN 3.4V
USB
Confirm you have installed the batteries and xD-Picture Card properly 
by pressing       . The "No Picture" message should be displayed in the 
monitor. Turn the camera off by pressing       again.
START HERE
It is strongly recommended that you follow these 
step-by-step numbered instructions to set up and 
quickly begin using your new Digital camera.
For more detailed instructions on advanced features, please refer
to the printed Basic Manual included in your package, or the 
Reference Manual on the CD-ROM.
UNPACKING THE BOX CONTENTS
Gather your Digital camera and the parts as shown in the illustration. You’ll need these to complete the steps for the 
camera set-up procedures that follow.
The following items are also included in this package: Basic Manual, warranty card, registration card (not pvovided in some 
areas), and safety precautions booklet.
Digital camera
Strap
AA (R6) alkaline 
batteries (x2)
CAMEDIA 
Master CD-ROM
xD-Picture Card
USB cable
(grey color)
TIP: To maximize battery life, the built-in power-saver operates, and the camera enters sleep mode after approximately three (3) minutes 
of non-use.
Before you begin using your Olympus Digital camera…
All you need to do is slide the lens barrier open or closed to turn the camera ON or OFF.
a.
Loading batteries
Note: The batteries and xD-Picture Card compartments are accessed by opening 
the respective compartment covers.
Attach the strap
 
(OPTIONAL)
Attach the strap as illustrated to make the camera easier to handle.
   • Close the battery compartment cover so that it pushes the batteries down inside. While pressing 
the        mark, slide the cover in the opposite direction of        .
   • To remove the batteries, make sure that the monitor and the lamps at the side of the viewfinder
are off.
   • Open the card cover. 
   • Face the card the correct way and insert it into the card slot. 
   • Insert the xD-Picture Card into the spring-loaded card slot as 
shown in the illustration. Push the card fully into the slot. The 
card will lock into place when fully inserted.
   • To remove, push down on the xD-Picture Card. The card will 
pop up. 
      Pull to remove.
   • Close the card cover securely. 
c.
Insert the xD-Picture Card
 
The xD-Picture Card is where the camera stores your pictures and is available in a variety 
of memory capacities. The pictures you take with the camera 
remain on the xD-Picture Card even when the camera is turned 
off and/or the batteries are removed. 
b.
a.
Set the Date and Time 
(OPTIONAL)
Although this is not required, it is recommended that you set the date and time. This affects the way image 
file names are created, and will conveniently include this information with each picture. The date and time 
can also be set when the camera is in the playback mode. 
   
• Open the lens barrier fully until it clicks.
   
• Press           to display the top menu.
   • Press    to select MODE MENU.
   • Press      three times to select SETUP.
   • Press    once, and then      once to highlight     , and then press    once.
   • Use           to select the date format.
   • Adjust the date and time in the appropriate fields by using    to select the field, and           to set 
the proper value. Repeat this step until all date/time fields have been set.    
   
   • Press           twice to set the date and time and exit the menu.
c.
TURNING ON THE CAMERA
Turn the camera ON 
(SHOOTING MODE)
    •
Open the lens barrier.
    •
Close the lens barrier to turn the camera off.
b.
Note: Time is entered using the 24-hour format.
Camera Diagram and Controls
Now take a moment to familiarize yourself with the key areas of camera controls by reviewing the illustrations.
Camera Settings in Shooting Mode as shown in Monitor
Camera Settings in Playback Mode as shown in Monitor
Print reserveation
PREPARE THE CAMERA FOR USE
Note: Depending on the camera settings, not all indicators 
will be displayed.
Power on
Power off
VT782801
Printed in China
Strap eyelet   Card cover
Connector cover
DC-IN jack (3.4V)
USB connector
When using AA (R6 batteries), also refer to 
the mark on the bottom of the camera that 
shows the correct way to insert batteries.
   • Close the lens barrier fully.
   • Slide the battery compartment cover in the direction of   
(the direction indicated by the        mark on the cover), 
and lift it up in the direction of      .
   • Insert batteries in the direction shown in the illustration.
A
B
http://www.olympus.com/
QuickStart Guide
D-395 / C-160
Olympus Europa GmbH
Wendenstrasse 14-18, 
20097 Hamburg, Germany
http://www.olympus-europa.com
OLYMPUS AMERICA INC.
Two Corporate Center Drive, Melville,
NY 11747-3157, U.S.A. 
http://www.olympusamerica.com/support
B
A
Notch
When the card is 
inserted properly.
Index area side
Strap eyelet
Flash
Shutter button
Self-timer lamp
Lens barrier
Lens
Lens barrier
Orange lamp
Green lamp
Arrow pad 
OK/Menu button 
Viewfinder 
Monitor 
QUICK VIEW button
Playback button (       )
Battery compartment cover
Tripod socket
Battery check
Flash mode
Self-timer
(still pictures only)
Number of storable still pictures/
seconds remaining for movies
Green lamp
Flash stadby
AF target mark
White balance
Spot metering mode
Record mode
Resolution (number of pixels)
Shooting mode
Macro
Exposure compensation
Number of prints
Battery check
File number
Protect
Record mode
Number of pixels
Exposure compensation
White balance
Date and time
Frame number,Playing time/
Total recording time