Bunn LCC-2 LP 操作ガイド

ELECTRICAL REQUIREMENTS

Refer to Data Plate on dispenser, and local/national electrical codes to determine circuit requirements.

WARNING - If the power cord is ever damaged, it must be replaced by the manufacturer or its service agent with

a special cord available from the manufacturer or its service agent in order to avoid a hazard.

The 120V version of the LCC-2 LP dispenser is supplied with a 120-volt / 15 Amp cord set and require a 2-wire,

grounded, individual branch circuit rated for 120 volts AC, 15 amp, single phase, 60Hz. The mating connector

must be a NEMA 5-15R.

PLUMBING REQUIREMENTS

The dispenser may be connected to a cold or hot water system (140°F Max.) with operating pressure between

20 and 90 psi (138 and 620 kPa) from a 3/8” or larger supply line. A shut-off valve should be installed in the line

before the dispenser. Install a regulator in the line when pressure is greater than 90 psi (620 kPa) to reduce it to

50 psi (345 kPa). The water inlet fitting is 1/4” flare. Dispensers set up to deliver to 47.3 ml/sec (1.6 Oz./sec.)

and require a water supply source that can deliver a minimum of 1.7 gpm (6.4 lpm) at the inlet fitting.

NOTE: Bunn-O-Matic recommends 1/4” tubing from the 3/8” water supply line. At least 18 inches of FDA

approved flexible beverage tubing, such as reinforced braided polyethylene or silicone, before the dispenser will

facilitate movement to clean the counter top. Bunn-O-Matic does not recommend the use of a saddle valve to

install the dispenser. The size and shape of the hole made in the supply line by this type of device may restrict

water flow.

INTRODUCTION

The LCC-2 LP BUNN Low Profile dispenser delivers two types of coffee made from liquid concentrate plus

hot water. The dispenser can be set up for continuous draw (by the cup) for self-serve applications, or portion-

control to fill carafes and decanters for wait staff. Follow the Concentrate Manufacturer’s Storage and Shelf Life

recommendations.

This dispenser is designed to operate when ambient temperatures are from 32°F (0°C) minimum to 95°F

(35°C) maximum.

BUNN recommends the use of our Easy Clear

Water Quality Systems to assure perfect taste.

Filter Kit - Easy Clear EQ-11-TL Bunn-O-Matic part no. 30344.1001

This equipment must be installed to comply with the Basic Plumbing Code of the Building

Officials and Code Administrators International, Inc. (BOCA) and the Food Service Sanita-

tion Manual of the Food and Drug Administration (FDA). For models installed outside the

U.S.A., you must comply with the applicable Plumbing/Sanitation Code for your area.

39288 031207