Avaya 9630 ユーザーガイド
Fastening the Belt Clip
Issue 1 May 1999
3-17
Fastening the Belt Clip
To fasten the belt clip to the WT (or battery pack), refer to the following figure and
set of instructions.
set of instructions.
Figure 3-3.
Fastening the Belt Clip
1. Hold the WT (or battery pack) so that the back of the WT (or battery pack)
is facing you.
2. Hold the belt clip so that it looks like the letter “T.”
3. Latch the right edge of the belt clip into the corresponding groove on the
inner side of the battery pack. (The groove is about 1/4 inch from the top of
the battery pack.)
the battery pack.)
4. Push the left edge of the belt clip and snap it into the corresponding groove
on the inner side of the battery pack.
(...then push
Belt Clip
Back of WT
Battery Pack
(outside)
(outside)
(Latch...)
and snap)