Epson 5300 ユーザーズマニュアル
4 • Using the ELP Link III Software
94
Installing the Software for a Macintosh
Follow these steps to install the software for the Macintosh:
1. Insert the Projector Software CD into your CD-ROM drive.
2. Open the CD-ROM drive icon, if necessary.
3. Double-click the Installer icon.
4. You see a dialog box asking you to select a language for the
software. Select a language and click OK.
5. You see the ELP Link III main menu. Click Install ELP Link III
V2.0.
6. You see the Software License Agreement screen. Read the
agreement and click Accept.
7. You see the Installer dialog box. Click Install. The installer copies
the program to your hard disk.
8. When the installation is finished, click Quit.
Launching the Software
Follow the steps in the appropriate section below to launch the
software. If you’re using the remote control as a mouse, use the pointer
button to position the cursor and the bottom multi-purpose button to
launch the software.
software. If you’re using the remote control as a mouse, use the pointer
button to position the cursor and the bottom multi-purpose button to
launch the software.
Note: If you have a Macintosh, your screens may look slightly different
than the screens in this chapter.
than the screens in this chapter.
5300.book Page 94 Tuesday, April 13, 1999 4:19 PM