Epson 1080 インストール手順
3
When done, press the
Pattern
button to clear the displayed pattern.
Note: If the projector is ceiling-mounted or set up for rear-screen projection, you’ll use the
projector’s menu system to reorient the image (see step 1 on page 4). For best image quality,
avoid tilting the projector or angling it toward the screen.
projector’s menu system to reorient the image (see step 1 on page 4). For best image quality,
avoid tilting the projector or angling it toward the screen.
7. Press the
HDMI
button on the remote control to select HDMI as the input source.
8. Turn on the power switch on the back of the HQV video processor (above the AC power
inlet). It may take several seconds for the video processor to come on.
9. Press the
ON/SETUP
button on the HQV remote control to place the video processor in
Setup mode. (You see
SetUp Mode
on the display.)
Note: If the HQV video processor doesn’t respond to the remote control, check the remote
control’s batteries. If the batteries are good, turn off the HQV video processor and then turn it
back on using the power switch above the AC power inlet.
control’s batteries. If the batteries are good, turn off the HQV video processor and then turn it
back on using the power switch above the AC power inlet.
Press the
MENU
button. Then use the u and d buttons to select the output
resolution setting (“Output = xxx”). Use the l and r buttons to change the setting
to
to
Output = 1080p 60Hz
.
Press the
ON/SETUP
button on the remote control to exit Setup mode.
10. Make sure the projector is displaying an image. If not, turn on a connected video source
and select it by pressing the appropriate source button on the HQV remote control.
HDMI
button
button