TallyGenicom 930 ユーザーガイド

E-10

Section 1

Media

Setting

12-20 lb paper ............................ 1
20-24 lb bond paper ................... 2
Labels ........................................ 3-4
Envelopes .................................. 4-5
2-part form (with carbon) ........... 1-2
3-part form (with carbon) ........... 2-3
4-part form (with carbon) ........... 3-4
5-part form (with carbon) ........... 4-5
6-part form (with carbon) ........... 5

To switch from single-sheet feed to continuous forms:

1. Press

FF/LOAD

to remove the single-sheet paper.

2. Lower the paper separator into the continuous-forms

position and swing the wire feed guide over onto the
pull-up roller.

3. Move the paper lever to the position marked “REAR” or

“BOT,” as appropriate.

4. If necessary, load continuous-form paper.

5. Press

FF/LOAD

Setting the Printhead Gap

The printhead gap is the distance between the printhead
and the platen.

Note: Make sure the printer is turned off before you

open the access cover.

To adjust the gap, open the access cover and move the blue
lever (

Ê) to the recommended setting from the table.

Sec1.p65

10/3/97, 9:28 AM