TallyGenicom la650 ユーザーガイド

Problems with the paper feed
The paper is not fed in

1 Check that the display shows the correct paperway, if neces-

sary select the correct paperway (single sheet or fanfold) with 
the key Park. See 

 (page 26). If you 

wish to use optional paper types, make sure they are correctly 
installed.

2 Make sure that the paper guide is correctly adjusted at the side.

3 When using single sheets, push the paper fully into the paper 

feed.

4 Check that the fanfold paper is in the park position when you 

insert a single sheet. This means the fanfold paper should not 
be loaded (pulled in). To check this, raise the guide of the single 
sheet feeder.

1 Open the top cover. If a paper jam should occur, then remove 

the jammed paper by tearing it off at the tear off edge (the tear 
off edge is located at the outfeed for the fanfold paper).

2 Press the 

 key to transport the paper backwards.

3 You may support the paper return feed by cautiously pulling the 

paper in the correct direction.

Before you replace the fanfold paper, refer to the instructions in the 
section 

 (page 28).

You should pay special attention to the following points:

`

Insert the paper straight.

`

After inserting the paper, close the tractors.

`

Adjust the tractors, the paper should be positioned in the trac-
tors straight but without tension.

`

Adjust the print head gap to the paper thickness (if AGA=Off).

`

Set the parameter Head-up to On, see section 

`

Clean upper friction, see section