TallyGenicom la650 ユーザーガイド

If the printer detects an internal fault or user error or if it expects you 
to do something, a message will appear in the LC display. It also dis-
plays the status during an operation (e.g. Loading default). Below 
you will find a list of messages with brief descriptions of each mes-
sage. The messages are described in greater detail in the chapter 

Eject error

The printer cannot eject the paper / 
advance it to park position. 

Hardware Alarm

Internal hardware error, contact your 
dealer or service technician. 

Head hot

The printer reports that the print head is 
hot and that print speed will be reduced.

Initializing

This message appears during the 
printer’s initializing phase. 

Load error

The printer cannot draw in the loaded 
paper.

Loading default

Indicates that the printer is being initia-
lised and is carrying out the internal self-
test immediately after turning on the 
printer. Factory defined parameters will 
be reloaded in all available menues.

Out of paper

The printer has detected paper end dur-
ing operation / printer was switched on 
with no paper loaded.

Parity error

A parity error during data transmission is 
indicated.

Press any key

The user is requested to press any key.

Tear Paper off

The user is requested to tear off paper 
which has been advanced to the quick 
tear edge.

Selftest

After power-on, the printer executes a 
short hardware self-test.